ghcup-hs/3rdparty/zlib/Codec/Compression/Zlib.hs

117 lines
3.5 KiB
Haskell
Raw Normal View History

-----------------------------------------------------------------------------
-- |
-- Copyright : (c) 2006-2014 Duncan Coutts
-- License : BSD-style
--
-- Maintainer : duncan@community.haskell.org
--
-- Compression and decompression of data streams in the zlib format.
--
-- The format is described in detail in RFC #1950:
-- <http://www.ietf.org/rfc/rfc1950.txt>
--
-- See also the zlib home page: <http://zlib.net/>
--
-----------------------------------------------------------------------------
module Codec.Compression.Zlib (
-- | This module provides pure functions for compressing and decompressing
-- streams of data in the zlib format and represented by lazy 'ByteString's.
-- This makes it easy to use either in memory or with disk or network IO.
-- * Simple compression and decompression
compress,
decompress,
-- * Extended api with control over compression parameters
compressWith,
decompressWith,
CompressParams(..), defaultCompressParams,
DecompressParams(..), defaultDecompressParams,
-- ** The compression parameter types
CompressionLevel(..),
defaultCompression,
noCompression,
bestSpeed,
bestCompression,
compressionLevel,
Method(..),
deflateMethod,
WindowBits(..),
defaultWindowBits,
windowBits,
MemoryLevel(..),
defaultMemoryLevel,
minMemoryLevel,
maxMemoryLevel,
memoryLevel,
CompressionStrategy(..),
defaultStrategy,
filteredStrategy,
huffmanOnlyStrategy,
) where
import Data.ByteString.Lazy (ByteString)
import qualified Codec.Compression.Zlib.Internal as Internal
import Codec.Compression.Zlib.Internal hiding (compress, decompress)
-- | Decompress a stream of data in the zlib format.
--
-- There are a number of errors that can occur. In each case an exception will
-- be thrown. The possible error conditions are:
--
-- * if the stream does not start with a valid gzip header
--
-- * if the compressed stream is corrupted
--
-- * if the compressed stream ends permaturely
--
-- Note that the decompression is performed /lazily/. Errors in the data stream
-- may not be detected until the end of the stream is demanded (since it is
-- only at the end that the final checksum can be checked). If this is
-- important to you, you must make sure to consume the whole decompressed
-- stream before doing any IO action that depends on it.
--
decompress :: ByteString -> ByteString
decompress = decompressWith defaultDecompressParams
-- | Like 'decompress' but with the ability to specify various decompression
-- parameters. Typical usage:
--
-- > decompressWith defaultCompressParams { ... }
--
decompressWith :: DecompressParams -> ByteString -> ByteString
decompressWith = Internal.decompress zlibFormat
-- | Compress a stream of data into the zlib format.
--
-- This uses the default compression parameters. In partiular it uses the
-- default compression level which favours a higher compression ratio over
-- compression speed, though it does not use the maximum compression level.
--
-- Use 'compressWith' to adjust the compression level or other compression
-- parameters.
--
compress :: ByteString -> ByteString
compress = compressWith defaultCompressParams
-- | Like 'compress' but with the ability to specify various compression
-- parameters. Typical usage:
--
-- > compressWith defaultCompressParams { ... }
--
-- In particular you can set the compression level:
--
-- > compressWith defaultCompressParams { compressLevel = BestCompression }
--
compressWith :: CompressParams -> ByteString -> ByteString
compressWith = Internal.compress zlibFormat